What are the benefits of a solar-powered submersible bore pump?

Posted by on Jun 17, 2016 in Uncategorized | Comments Off on What are the benefits of a solar-powered submersible bore pump?

A bore pump is a type of submersible water pump that is able to draw up or deliver water from below ground. There are many uses for this type of pump, from agriculture to rural residential uses. With the bore pump, it has a pump that uses force in order to bring water from underground to a tank located above ground. Some of these pumps are solar-powered, which uses installed solar panels to provide natural UV energy for using the pump, providing a wide range of benefits. Consider these benefits to having a bore pump that is powered by solar energy. The Pump Can Be Used in Any Rural Area In many cases, the bore pump is needed in areas that are more rural or not anywhere close to power lines. With a solar-powered water pump, all it needs is enough sunlight and solar panels in order to build up solar energy. This makes the pump more mobile-friendly, where it can be placed anywhere without having to worry about how close the power lines are. This is why it is used so often for agricultural industries that often need it for their livestock or farming purposes. You Don’t Rely On Local Utilities If you use a bore pump that is connected to the local power lines, this requires the utilities to be active in order to use the pump. What if there was a power outage? You would then be out of luck and would not be able to use the pump unless you had stored energy from previous uses. With a solar-powered pump, you don’t need to worry about when the power is turned on or possible outages due to severe weather conditions. As long as you have sunlight, you have a way to power the pump. Taking Care of Livestock is a Breeze When you have a lot of land with livestock, it can be a real pain having to get water from a well, then bringing it to where your livestock is. With a solar-powered water pump, you can move it closer to where your animals are or use multiple pumps throughout your land. This allows for more distribution points for the water. It also keeps the animals from drinking from waterways on your land, which can ultimately lead to that water becoming contaminated. They Are Low-Maintenance Since you aren’t using traditional energy sources for the water pump, you have an option that requires minimal maintenance. Once the pump and solar panels are installed, the rest doesn’t require much upkeep. Aside from the occasional repairs for the pump or storage tank, it is mostly...

read more

Where to place a constructed wetland

Posted by on Feb 10, 2016 in Uncategorized | Comments Off on Where to place a constructed wetland

Constructed wetlands are excellent ways of storing water in a natural environment, which can provide benefits for the ecosystem in the area. Getting a constructed wetland for your property or land is a complicated procedure that requires advice and expertise from professionals to be done well. However, before you decide if a constructed wetland is for you, you need to decide the location for it. Without knowing this, it’s not certain it will be plausible at all. Natural wetland If there is a natural wetland somewhere on your land, avoid placing a constructed wetland too close to it, so that you do not disturb the ecosystem. Placing a constructed wetland near the natural wetland will confuse wildlife that the constructed wetland is their new habitat, as opposed to the natural one. It’s also important that the contaminated water that is being treated in the constructed wetland doesn’t come in contact with the natural water supply, as this might damage the ecosystem as well as make the process of treating your water less effective. Appropriate soil As constructed wetlands are meant to hold water, you also need to consider what soil you have in different locations. Sandy soil will absorb an unnecessary amount of water and make the bottom of the wetland unstable. Buying additional lining is a possible option if you truly have no other options and you really need that constructed wetland, but it’s an expensive option. Firm clay soil with low water content provides the optimal conditions for a constructed wetland. If it’s too wet, it won’t form a stable base for your constructed wetland, and you’ll need to treat it to keep it waterproof. Firm clay soil will form a waterproof base without you having to spend any extra money. Safety margin Because of safety, you’ll also need to have a margin to the wetland that you need to take into consideration when looking for places to put it. Make sure that there are no trees or shrubs lining the planned wetland and that they are being kept well away from the area, as these will limit visibility around the wetland, which might be dangerous for people working in the area. You should also avoid an area which has a downward slope leading to it. The downward slope would not count as part of the safety margin, as it only makes it easier for people to slide down and fall into the wetland.  ...

read more

What To Look Out For When Buying A Water Tank Pump

Posted by on Nov 5, 2015 in Uncategorized | Comments Off on What To Look Out For When Buying A Water Tank Pump

If you have just invested in a water tank, you need a proper-functioning pump to ensure that your collected rainwater is put to good use. Water tank pumps can also come in handy when you need to boost low-pressure mains water and get it into the tank. However, in order to do all that, you need to get the right pump for your tank and needs. Below, find out the different factors you need to consider as you do so. Flow rate   First, check the flow rate of the pump. The flow rate refers to how much water the pump can ‘move’ within a given time frame. Most pumps have a ‘litres/min’ rate. The right flow rate will depend on the size of your tank. The larger it is, the higher your pump’s flow rate should be. If the flow rate is too low in comparison with your tank, it will take too long before you can fill/empty it. Suction lift Suction lift is the maximum vertical distance your tank can pump water, i.e. how high up your water can get pumped. If your pump does not have enough suction lift, you will not get water to your intended destination. You can determine the suction lift required by checking how high up your indoor storage tank is; your pump’s suction lift should be slightly higher than that. Pump type There are several types of water tank pumps you can get. The most applicable are submersible and centrifugal pumps. A submersible pump goes inside the tank. However, this one is only ideal if you intend to use the pump only to pump water out of it. A centrifugal pump, on the other hand, is located outside the tank. It will allow you to pump water to several outlets and from several sources, e.g. mains or underground tanks. Power consumption Power is an important consideration to factor when selecting your pump. With electric pumps, you can check power consumption by checking how many watts your pump consumes. The higher this figure is, the more power your pump will consume. The right wattage depends on how many outlets and litres of water you intend to pump per session. To gauge if a pump has an acceptable wattage, compare it with what similar pumps have. Automatic function Automatic function in a pump is important. It allows a pump to turn on and off automatically when you open or shut your taps. This function therefore frees you from the laborious manual operation. In addition to that, automatic function ensures the pump can safely shut itself off when the tank runs dry to avoid damaging the pump. Noise Last but not least, check how noisy the pump is. Noise is rated in decibels (dB). Of course, the less noise your pump makes, the better. However, expect that your pump will still create some noise when operating. If you select your water tank pump with the above considerations in mind, you are bound to buy a unit that will serve your every need for years to...

read more

3 Reasons You May Want Private Water Testing for Your Home

Posted by on Aug 17, 2015 in Uncategorized | Comments Off on 3 Reasons You May Want Private Water Testing for Your Home

Most cities and municipal organisations will perform water testing in water treatment centres or locations, perhaps taking advantage of the services provided by companies like Agrifood Technology to make sure water is safe. Though this information is available to the public, it may not paint the picture of what the water in your home is doing. This could be for a number of reasons, including things like old pipes and issues with the plumbing leading water to your home. Here are a few instances when you may want to have private water testing for your home and for your health. Foul Taste in the Water If you start noticing a foul taste in your water, like a sour or a chemical taste, then you may want to have private water testing for your home. This could mean your filters are not working properly or that you have an issue in the pipes causing some kind of build-up or residue to deposit in your drinking water. If the water testing lab does show that there is a higher amount of a certain chemical in your water, or an issue in the water, they may suggest using a particular type of filter to catch this residue or chemical before it passes into your drinking water. Ongoing Stomach Illnesses Having a stomach virus or upset stomach on occasion is something you may be concerned with, but if this same stomach issue occurs on a routine basis or never seems to go away, then you may want the water checked. A water testing lab can test the water to determine if something in the drinking water is causing these issues. They can also test the area water to see if it is just your home or if it is in your neighbourhood. This can be a serious issue that may require new pipes or be as extensive and far-reaching as the local water department changing levels to ensure there are no problems with the area water supply. Old Plumbing Issues One reason you may want to have private water testing for your home is due to old plumbing and related issues. You may need to check and see how the water from those pipes tests and if the pipes really need to be replaced. The water testing can show if the internal pipes are depositing anything into your water, if it is dangerous and if filters would help. This can help make some tough financial choices on having pipes replaced or having filters installed instead. These are just a few reasons that you, as a homeowner, may want to have private water testing. Remember that most water testing will require you to wait as the tests are sent to and analysed by a water testing lab. The lab will send you the results and you can make the proper choices and changes at that...

read more